My company purchased a new Leitz 12106 machine about three years ago and believe it or not the Brown and Sharpe installation was completed just this week. (Not B&S's fault) I trained on Quindos about a year ago and have since forgotten much. Are there any people out there running a similar system that would be willing to help this green horn out? I have no PMM or CMM experience nor any programming experience of any kind. My field is Tool and Die and therefore have a basic knowledge of inspection principles but as for this beast, I'm, well you know what I'm up against. Are there any Quindos users groups out there? Any help or suggestions are greatly appreciated.

Thanks,

Mark Stailey