Jorge,

I don't think that your problem is a corrupted work cell.

I have found that the DMIS MODE/MAN does not work like you expect in Silma. I use the MODE/PROG,MAN mode to do the off line programming then when I move the program to the CMM I edit the DMIS line back to MODE/MAN and add a MODE/PROG,MAN or MODE/AUTO,PROG,MAN to the program after the manual touch.

This also saves time in Simulation or Step mode because you only pick the manual points once. You just click on run from beginning and it will run automatically through the manual touches.

Bob Connors
Lawrence Berkeley National Lab