Good Day to all. This is my first posting of questions. I am running a B&S CMM that utilizes pc-dmis software., ver. 3.0864. I have been told that you cannot report features of an alignment, ie. tooling balls,
directly after an alignment. Instead I should go back and re-measure these features and then report them. Is this true? I would also like to know if it is possible to hide or "mask" all DF features in a report, without using the "F3" key? One of our QEs' made this request. I am still fairly new at using pc-dmis. Any help would be appreciated.

Best Regards, Peter Warcholyk