On 4/23/01 11:17:41 AM, Peter Warcholyk wrote:
>Good Day to all. This is my
>first posting of questions. I
>am running a B&S CMM that
>utilizes pc-dmis software.,
>ver. 3.0864. I have been told
>that you cannot report
>features of an alignment, ie.
>tooling balls,
>directly after an alignment.
>Instead I should go back and
>re-measure these features and
>then report them. Is this
>true? I would also like to
>know if it is possible to hide
>or "mask" all DF features in a
>report, without using the "F3"
>key? One of our QEs' made this
>request. I am still fairly new
>at using pc-dmis. Any help
>would be appreciated.
>
>Best Regards, Peter Warcholyk
>

Welcome Peter,
First of all, also try pc-dmis.com for software related questions.You can definetly report out the features you used to build your alignment, why not ? Maybe someone meant not until after you have the alignment...
I`m not sure what you mean by DF features....I will guess you mean certain dimensions, yes you can choose not to dimension out any measurement. I hope this helps and that we can all help you in the future. cheers, Jim

jim.jewell@valiantmachine.com