How can I do polar checks in LK-DMIS. I need to do this while in non-programmed command mode. It should be real simple. Set origin to center of nominal radius, set coordinates to polar, then take the point. Some other notes
1) Do not want to type in the nominal radius.
2) Do not want to type in nominal angle of hit point
3) Hit must be taken manually.
Real simple problem, set this part up and tell me what this radius is. Not enough of an arc to do a diameter check then divide by 2. Is there a real simple solution that does not require writing a program for each particular part?

John Foreman
Chrysler, Kokomo Casting Plant