I am once again presented with the tooling ball alignment problem. I never did get it resolved before. I have an LK-G80 with Picture Programmer software. DOS/CMES. I have a large auto fuel door in-car gage. It has 3 tooling balls on the base. The tooling ball locations are:

1.
X - 4300.02
Y - -750.056
Z - 861.861

2.
X - 4299.824
Y - -1099.955
Z - 862.005

3.
X - 4800.066
Y - -1100.165
Z - 862.018

Diagram:
1. O



2. O_______3. O

Could anybody tell me how I can create the alignment in Picture Programmer/DOS/CMES software? Does someone know the program formula for this? I would greatly appreciate any help I can get.
Thanks,
Vicki Havard