Previous | Next | G. D. & T.
Topic: Aligning parts with slots, 1 Attachments
Conf: G. D. & T., Msg: 3321
From: Duane Wade (dwade@teleflex.com)
Date: 9/24/2001 01:06 PM

Attached is a sketch of the part and the dilemma of aligning parts with slots.

I measure and align per figure 1. the method shown in figure 2 is the other method (symmetry point) and then evaluation is done on the remaining area(s) of the slot surfaces.

More ideas please.

Duane Wade
CMM/Gage Technician
TeleFlex Automotive - Pedals Division
301 W Ohio St.
Kendallville, In 46755
219-349-1985
dwade@tfxauto.com

Click to open!slot.jpg
slot align (57,963 bytes)