I use LK DMIS. MMC should be supported by all
CMM software systems. If you have any questions, call me.

DATDEF/FA(-E-),DAT(E)
F(CR0)=FEAT/CIRCLE,INNER,CART,6.0252,0,2.93,0,0,1,0.257
MEAS/CIRCLE,F(CR0),4
ENDMES
T(5)=TOL/POS,2D,0.005,MMC,DAT(E),MMC
T(6)=TOL/DIAM,-0.001,0.005
OUTPUT/FA(CR0),TA(5),TA(6)
F(CR1)=FEAT/CIRCLE,INNER,POL,6.025,30,2.93,0,0,1,0.257
MEAS/CIRCLE,F(CR1),4
ENDMES
OUTPUT/FA(CR1),TA(5),TA(6)

Bill Rogers
Quality Engineer
Lockheed Martin Corp.
Missiles & Fire Control
Orlando, Fla.
Phone: 407-356-0621
Pager: 407-981-7613
E-mail: william.e.rogers@lmco.com