Previous | Next | Mitutoyo
Topic: Inverted Cone when using GeoMeasure 6k Automeasue, 1 Attachments
Conf: Mitutoyo, Msg: 4539
From: Tom Coleman (tom@dallasmachining.com)
Date: 2/16/2003 08:33 PM

I'm attempting to measure a 20 degree angle on a part using the Cone feature. When Auto Measure is used the "vector-ing" of the probe is in the Z-positive direction as if the cone was inverted. Has anyone run up on this yet? Is there a solution?

Click to open!Cone.dwg
Part Drawing (65,988 bytes)