I was the original "Deleted User" of this post. Just wanted to connect my identity to it for reference.
On 4/18/2000 3:57:55 PM, Deleted User wrote:
>Hey Donavon,
>Yes Usoft does have a learn
>mode. You start a program by
>pressing the F5 key learn
>start.
>Next set your status and DCC
>status. Then add the header
>and select a probe system and
>tip. Next recall or construct
>your part alignment. The rest
>is basic CMM measurement
>stuff. Press learn end F5 and
>give your program a name ie.,
>a number. For example all my
>programs are named by job
>number 890101 for left hand
>890102 for right hand. Sorry
>so late in response, I just
>got back on CMM World.