I am having problems with radius measurement. Looking at the attached drawing you'll understand why. The arc length of the radii are fairly short but I can get repeatable results off of one end but not the other. The radii were all measured as a scan and then edited to a diameter measurement. The balloons for 36, 41, 43, 44 and 46. The dims from the intersects and the radii sizes comes out good every other part. The radii for balloons 41 and 49 are measured with about 30 points each and the radii for balloons 43 and 48 are measured with approximately 45 points each. Any ideas why it works one time and not the next?

I have GeoMeasure V2.02.1
Duane Wade
Metrologist
TeleFlex Automotive - Pedals Division
301 W Ohio St.
Kendallville, In 46755
219-349-1985
dwade@tfxauto.com

996T-G4011.pdf
(62,744 bytes)