Previous | Next | Mitutoyo
Topic: MMC bonus for zero true position FCFC
Conf: Mitutoyo, Msg: 5018
From: Duane Wade (dwade@teleflex.com)
Date: 9/15/2003 01:21 PM

I have a ppg that I have ran before that has a FCF with zero true position with MMC. I did not notice this the last time but if I do not have any MMC bonus from the size of the diameter I get an error for this. Is this not allowed in GeoMeasure if there is no MMC bonus? I don't remember what the diameter sizes were like the last time I ran them.

I have GeoMeasure 6000 V2.02.1

Duane Wade
Metrologist
TeleFlex Automotive - Pedals Division
301 W Ohio St.
Kendallville, In 46755
219-349-1985
dwade@tfxauto.com