Needed immediately.

We are in need of a person for programming and operation of 2 Mitutoyo CMMs. We have a Mitutoyo Bright 1220 (2 yrs old) and a new Mituyoyo Crysta 7106 (to be installed Dec 7th). We are in the process of expanding our CMM/layout operations to include outsourcing for PPAP layout, capability studies and programming (GeoMeasure only). This position is for 2nd shift.

The job duties include (but are not limited to) programming and operation of the CMM(s), gage calibration, providing assistance to 2nd shift setup personnel, tool & die makers, and in-process inspection of production machining components.

We are ISO 9000 certified and in the future look to be ISO 17025 certified so gages and fixtures can be included into our scope of measurement.

This position is located in Albion, Indiana. Wages are negotiable and DOE.

Resumes are accepted via postal mail or email. Email to athomas@engineeredtool.com or mail to the address below.

Engineered Tool Division
600 S. 7th Street
Albion, In 46701
Attn: Amy Thomas
http://www.engineeredtool.com



Duane Wade
Quality Technician
Engineered Tool Division
600 S. 7th Street
Albion, In 46701
dwade@engineeredtool.com