Calibration of cylinder styli

Previous | Next | Mitutoyo

Topic: Calibration of cylinder styli
Conf: Mitutoyo, Msg: 837
From: Deleted User
Date: 7/16/1999 10:08 AM

Hi all,
I am having a problem calibrating a steel cylinder stylus, Ų1.5mm with a flat end, i.e no radius. Renishaw part no. M-5000-4152, PS no. PS18R. As there is no radius on the end of the stylus, I cannot get a true representation of the stylus Ų inputted into the m\c. Has anyone overcome this problem, and if so, can you pass on your fix. Both Mitutoyo and Renishaw cust. serv. have been poor on the resolution of this small but thorny problem.

Thanks in advance,

Ivan